Introduction of Door Frame Making Machine

The drive system of the anti-theft door frame making machine mainly consists of pump direct drive and pump-accumulator drive these two type. The anti-theft door frame making machine provides a high-pressure working fluid, the flow-receiving valve is used to change the direction of the liquid supply, and the relief valve is used to adjust the limited pressure of the system and function as a safe overflow at the same time.

The anti-theft door frame making machine adopts the hydraulic compression molding of the table mold and the vibration, the molding cycle is short, and the production efficiency is high. Use the anti-theft door frame making machine to be more environmentally friendly, more energy efficient, and waste recycling. The anti-theft door frame making machine adopts the three-bar upper and lower pressure to form at one time, and does not need any piece of brick board. The anti-theft door frame making machine belongs to the * model of the domestic block brick. The anti-theft door frame making machine is a machine that uses liquid as working medium to make a door frame according to the Pascal principle.

The anti-theft door frame making machine, also known as the unpacking machine, refers to the special equipment which can conduct automatic completion of unpacking, forming, and bending of the lower bottom flap. And completing the lower part tape pasting for realtime, opening the box board which is stacked into cardboard, and the bottom of the box is folded according to a certain procedure, and sealed with a tape and then delivered to the boxing machine. The anti-theft door frame making machine is all controlled by PLC+ display, which is very convenient for operation and is an indispensable equipment for automatic scale production.

The anti-theft door frame making machine works similarly to the syringe for injection. It uses the thrust of the screw (or plunger) to inject the plasticized molten state (ie, the viscous flow state)plastic into the closed cavity. Which is the technical process of obtaining the product after curing and setting.